Back to AION420
AION420 · Signal routing

Terminated – the adapter ends the current loop

With the terminated variant, the AION420 is the only receiver of the 4–20 mA signal. The current loop ends in the adapter – the reading is transmitted over LoRaWAN® or mioty®.

At a glance

Signal path
Sensor → AION420 → radio
Existing evaluation
Not required
Typical for
New or unused measuring points
SensorAION420LoRaWAN®/mioty®

4–20 mA · Terminated

01

Simplest wiring

Connect the sensor and you are done – no need to consider an existing controller or display.

02

Ideal for retrofitting

Measuring points that were never captured come online without touching the plant.

03

One receiver, one signal

The adapter terminates the loop cleanly – no duplicate receivers, no burden issues.

How to proceed

  1. 1.Check that no other receiver (PLC, display) is on the loop
  2. 2.Wire the sensor according to the terminal diagram
  3. 3.Scale the range via BLE
  4. 4.Check the reading via BLE and test the radio link

If the signal is also needed by a controller, the loop-through variant is the right choice.

AION420 in the Sentinum shop