Back to AION420
AION420 · Signal routing
Terminated or loop-through – two paths for the signal
The current loop can end in the AION420 – or continue through it to the existing evaluation. The choice depends on whether the signal is already used.
At a glance
- Terminated
- Adapter is the only receiver
- Loop-through
- Signal continues to evaluation
- Selection
- By installation
Terminated
Sensor → AION420 → radio. Ideal for new or previously unused points without a controller.
SensorAION420Funk
Loop-through
Sensor → AION420 → controller, radio in parallel. The existing display or PLC keeps running unchanged.
SensorAION420SPS+ Funk
How to proceed
Check whether the signal is already evaluated
No receiver → terminated
Controller or display present → loop-through
Check loop burden against the datasheet
With loop-through the existing automation stays untouched – the radio data is added on top.
AION420 in the Sentinum shop